Aluminum system with thermal break for executing large-sized sliding openings with a minimalist concept, aiming to combine maximum transparency with minimal structural visibility.

Extruded profiles in aluminum alloy 6060 for architecture according to standard NP EN 12020-02.

The thermal break profiles are obtained by inserting 14.6 mm polyamide 6.6 rods reinforced with 25% fiberglass in fixed frames and 32 mm in movable frames. The average thickness of the aluminum profiles is 2 mm.

Perimeter or straight-cut fixed frame section of 82.7 mm mono-rail, 180 mm bi-rail, or 277.3 mm tri-rail.

Lower sliding guide profile in aluminum with high-performance double bearings or with a track guide, both in stainless steel.

This system includes solutions with embedded thresholds to allow integration into the flooring, as well as pre-frames for better and more effective application of the frames and more efficient drainage. There is also the possibility of applying interior or exterior trims.

Very reduced visible section of straight-cut movable frames with mechanical connection assembly;

Double or triple insulating glass with secondary silicone sealing from 34 mm to 56 mm total thickness composed of tempered or heat-strengthened exterior glass and tempered or laminated-tempered interior glass;

Recommended structural silicones for vertical glazing of glass: Dow Corning 895 black structural silicone or Sikasil SG20 black structural silicone;

Reinforced movable frames for large sizing;

Solution with mosquito net.

Minimum – maximum dimensions of manual opening leaf 500 mm – 2500 mm (L);

Minimum – maximum dimensions of manual opening leaf 500 mm – 4000 mm (H);

Maximum area of manual opening leaf: 10 m2;

Maximum weight of 450 Kg per manual opening leaf;

Minimum – maximum dimensions of motorized opening leaf 1000 mm – 3200 mm (L);

Minimum – maximum dimensions of motorized opening leaf 1700 mm – 5000 mm (H);

Maximum area of motorized opening leaf: 16 m2;

Maximum weight of 1000 Kg per motorized opening leaf;

Typologies from 2 to 6 leaves with movable and/or fixed leaves;

Possibility of corner opening or pocket opening;

The sliding of the leaves is done over a lower sliding guide profile in aluminum with high-performance double bearings in stainless steel or with a track guide in stainless steel for easy opening of the gap even in extreme weight or size configurations;

Typologies of openings with more than 98% luminosity;

Air permeability and water tightness ensured through state-of-the-art brush seals and marine-quality EPDM gasket;

Multipoint hardware with several easy-to-apply and adjust locking points, including the possibility of micro-ventilation;

Specific handles with lacquering or anodizing treatment to facilitate the opening and closing maneuver of the gap;

There is an option to apply a lock for exterior/interior opening.

System certified by a notified laboratory for Type Tests (TT) according to the product standard EN 14351-1:2006+A2:2016 for CE marking purposes.